The tap is an important part of a kitchen or bathroom. It allows us to uses water in that room. However, when the tap is broken or it gets stuck in a wall, we must repair it immediately. Additionally, if you’re too busy to do it, you can call the company of columbia sc plumbers.

You can read the information below to learn how to repair your broken pipe or when it’s stuck in a wall:

There are 6 tools and materials needed, such as:

1. A new tap.
2. A tap connection.
3. Some lighters.
4. A sheet pipe adhesive.
5. A patent adhesive.
6. Fine sandpaper.

The first step is to heat the tap connection. Heat it on the part that has no thread or thread. After it feels hot enough, try inserting it into the broken tap until the end of the connection can stick to the surface of the pipe is stuck in the wall. It takes one to two times to burn so that the connection feels right and sticks. It should be noted to heat the connection is not too soft or even light so it does not stick permanently.

This is because it still needs to rub the surface of the joint that has been burned with fine sandpaper so that it can stick flat on the end of the pipe is stuck in the wall.

Install the new tap after the end of the connection surface is quite flat. Installation is carried out on the only end that has a thread or thread.

Glue the end of the connection surface that has been burned earlier to the inside of about one centimeter using permanent glue. Glue is also the end of the pipe surface is stuck in the wall along with the base of the tap left in the pipe. Install the connection until it attaches well to the surface of the pipe is stuck in the wall.

The drying process is not too long around two to three hours so that it sticks well. Add more permanent glue to the outer surface after joining. An adhesive sheet can also be provided to make the joints stronger and prevent water leakage. Let stand dry first and can be used after half a day.